Question Set

1. When electronic emission occurs due to bombardment of high velocity electrons on a metal surface, it is called secondary emission.



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The process of emission of electrons from metal by UV rays is?....
QA->A​ ​light​ ​wave​ ​is​ ​incident​ ​over​ ​a​ ​plane​ ​surface​ ​with​ ​velocity​ ​X.After reflection​ ​the​ velocity​ ​becomes:....
QA->When yellow light is incident on a surface no electrons are emitted while green light can emit. If the red light is incident on the surface then?....
QA->The photoelectric effect is described as the ejection of electrons from the surface of a metal when?....
QA->The electrons are emitted in the photoelectric effect from a metal surface?....
MCQ->When electronic emission occurs due to bombardment of high velocity electrons on a metal surface, it is called secondary emission.....
MCQ->Consider the following statements Bunching of electrons occurs in two cavity klystron amplifier.Bunching of electrons occurs in multi cavity klystron amplifier.Bunching of electrons occurs in reflex cavity klystron amplifier. Which of the above statements are correct?....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->Assertion (A): Field emission is substantially independent of temperature. Reason (R): When a high electric field is created at metal surface field emission may occur.

....
MCQ->Consider the following statement If an electric field is applied to an n type semiconductor bar, the electrons and holes move in opposite directions due to their opposite charges. The net currents is both due to electrons and holes with electrons as majority carrierssum of hole and electron currentsdifference between electron and hole currents. Which of above statements are correct?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution