Question Set

1. The kinetic energy of free electrons in a metal is (where k is the de-Broglie wave number of the electron)





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->What is the number of electrons in an atom of atomic number Z and mass number A?....
QA->The ionisation energy of hydrogen atom in the ground state is x KJ. The energy required for an electron to jump from 2nd orbit to 3rd orbit is?....
QA->The number of waves made by an electron moving in an orbit having maximum magnetic quantum number is +3?....
QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....
QA->The wave nature of electron was suggested by whom?....
MCQ->The kinetic energy of free electrons in a metal is (where k is de-Broglie wave number of the electrons)....
MCQ->The kinetic energy of free electrons in a metal is (where k is the de-Broglie wave number of the electron)....
MCQ->Consider the following statement If an electric field is applied to an n type semiconductor bar, the electrons and holes move in opposite directions due to their opposite charges. The net currents is both due to electrons and holes with electrons as majority carrierssum of hole and electron currentsdifference between electron and hole currents. Which of above statements are correct?....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->Heat transfer by conduction results due to the transfer of free electrons, kinetic energy & vibrational energy from one molecule to another. Conduction heat transfer can not take place....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution