Question Set

1. The kinetic energy of free electrons in a metal is (where k is de-Broglie wave number of the electrons)




Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->What is the number of electrons in an atom of atomic number Z and mass number A?....
QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....
QA->വസ്തുവിന്റെ ഭാരവും വേഗതയും കൂടുന്നതിനു സരിച്ച് ഗതികോർജ്ജം (Kinetic Energy)?....
QA->If the Kinetic Energy of a body is increased by 300%; how much will its momentum increase?....
QA->At absolute zero temperature; what will be the kinetic energy of the molecules?....
MCQ->The kinetic energy of free electrons in a metal is (where k is de-Broglie wave number of the electrons)....
MCQ->The kinetic energy of free electrons in a metal is (where k is the de-Broglie wave number of the electron)....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->Heat transfer by conduction results due to the transfer of free electrons, kinetic energy & vibrational energy from one molecule to another. Conduction heat transfer can not take place....
MCQ->In the case of a centrifugal pump,the kinetic energy per unit weight of water is found to be 8 Nm and the work done per unit weight of water was 24 Nm.So the percentage of work converted into kinetic energy will be:....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution