Question Set

1. The circuit I in figure is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 12.55 am
    Current in the circuit is [2 v at '+' terminal and '-' terminal will be same].
Show Similar Question And Answers
QA->At the time of short-circuit; what will be the current in the circuit?....
QA->At the time of short-circuit, what will be the current in the circuit?....
QA->How much distance does the earth’s annual circuit round the sun cover?....
QA->Which is electrical circuits used to get smooth de output from a rectified circuit called?....
QA->ഐ.സി ചിപ്പ് (integrated circuit chips) നിർമ്മിക്കാൻ ഉപയോഗിക്കുന്ന മൂലകങ്ങൾ?....
MCQ->Pick out thể one word for - a secret arrangement....
MCQ->Which of the following conditions should be satisfied to call an astable multivibrator circuit using discrete components as a digital circuit? A flip-flop is always a digital circuit. Only when we assign 1 and 0 to the high and low levels of the output, a flip-flop is called a digital circuit. Only if the power, supply voltage is maintained at + 5 V or - 5 V, it is called a digital circuit. Only if it is in IC form, following the technology of IC manufacture, it is called a digital circuit.Select the correct answer from the codes given below:....
MCQ->The second figure in the first unit of the problem figures bears a certain relationship to the first figure. Similarly, one of the figures in the answer figures bears the same relationship to either the first or the second figure in the second unit of the problem figures. You are therefore to locate the figure which would fit in the place of the question mark(?).....
MCQ->AM amplifier having noise figure of 20 dB and available power gain of 15 dB is followed by a mixer circuit having noise figure of 9 dB. The overall noise figure as referred to input in dB is....
MCQ->Refer to the given figures (a) and (b). A logic analyzer is used to check the circuit in figure (a) and displays the waveforms shown in figure (b). The actual analyzer display shows all four data outputs, Q0-Q3. The analyzer's cursor is placed at position X and all four of the data output lines show a LOW level output. What is wrong, if anything, with the circuit?

....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution