Question Set

1. A switch tail ring counter is made by using a single D FF. The resulting circuit is a





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 12.56 am
    In both case input will always opposite to each other hence it is D FF.
Show Similar Question And Answers
QA->A girl started counting the fingers of her left hand, calling the thumb 1, the index finger 2, middle finger 3, ring finger 4, little finger 5 and then reversed the direction calling the ring finger 6 middle finger 7 and do on. She counted upto She ended counting on ……………… finger....
QA->Five bells ring at the intervals of 2,3,4,5 and 8 respectively. They will ring together after?....
QA->Six bells start ringing together and ring at intervals of 4, 8, 10, 12, 15 and 20 seconds respectively. how many times will they ring together in 60 minutes ?....
QA->At the time of short-circuit; what will be the current in the circuit?....
QA->At the time of short-circuit, what will be the current in the circuit?....
MCQ->A switch tail ring counter is made by using a single D FF. The resulting circuit is a....
MCQ->You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy? Switch(config-if)# ip access-group 10 Switch(config-if)# switchport port-security maximum 1 Switch(config)# access-list 10 permit ip host 1 Switch(config-if)# switchport port-security violation shutdown Switch(config)# mac-address-table secure....
MCQ->Read the following statements The circuitry of ripple counter is more complex than that of synchronous counter.The maximum frequency of operation of ripple counter depends on the modulus of the counter.The maximum frequency of operation of synchronous counter does not depend on the modulus of the counter. Which of the above statements are correct?....
MCQ->Which of the following sentences are correct about a switch loop in a C program? 1: switch is useful when we wish to check the value of variable against a particular set of values. 2: switch is useful when we wish to check whether a value falls in different ranges. 3: Compiler implements a jump table for cases used in switch. 4: It is not necessary to use a break in every switch statement.....
MCQ->4 bit ripple counter and 4 bit synchronous counter are made using flip-flop having a propagation delay of 10 ns each. If the worst case delay in the ripple counter and the synchronous counter be R and S respectively, then....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution