1. A scheme shown below is to generate a wide band FM modulate signal. Narrow band FM has carrier frequency = 400 KHz Deviation ratio = 0.2 Wide band FM has carrier frequency = 100 MHz Deviation ratio = 6 Frequency multiplication factor is:





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The ratio of bases of a cylinder and a cone are in the ratio 3: Volume of cylinder and cone are in the ratio 9: then their heights are in the ratio?....
QA->The piece of hardware that converts your computer’s digital signal to an analog signal that can travel over telephone lines is called a–....
QA->Frequency ranging from 300 MHZ to 3 GHz is called?....
QA->The fuel used to generate steam in Kayamkulam thermal power plant is?....
QA->The range of electromagnetic spectrum between 10 KHz and 1 GHz is called:....
MCQ->A scheme shown below is to generate a wide band FM modulate signal. Narrow band FM has carrier frequency = 400 KHz Deviation ratio = 0.2 Wide band FM has carrier frequency = 100 MHz Deviation ratio = 6 Frequency multiplication factor is:....
MCQ->A scheme shown below is to generate a wide band FM modulate signal. Narrow band FM has carrier frequency = 400 KHz Deviation ratio = 0.2 Wide band FM has carrier frequency = 100 MHz Deviation ratio = 6 Local oscillator frequencies can be....
MCQ->A carrier is phase modulated (PM) with frequency deviation of 10 kHz by a single tone frequency of 1 kHz. If the single tone frequency is increased to 2 kHz, assuming that phase deviation remains unchanged, the bandwidth of the PM signal is....
MCQ->A message signal with bandwidth 10 kHz is lower sideband SSB modulated with carrier frequency fc1 = 106 Hz. The resulting signal is then passed though a narrow band frequency modulator with carrier frequency fc2 = 109 Hz. The bandwidth of the output would be....
MCQ->A superheterodyne receiver is to operate in the frequency range 550 kHz - 1650 kHz, with the intermediate frequency of 450 kHz. Let denote the required capacitance ratio of the local oscillator and I denote the image frequency (in kHz) of the incoming signal. If the receiver is tuned to 700 kHz, then....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution