Question Set

1. In the circuit below, if diodes and the moving coil millimeter are assumed to be ideal if mA reading is , find Vm.





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 12.58 am
    Now, ∴ Im = p IDC = 0.1 mA ∴ Vm = Im x R = 0.1 mA x 10 K Vm = 1 Volt.
Show Similar Question And Answers
QA->A man started to walk East. After moving a distance he turned to his right. After moving a distance he turned to his right again. After moving a little he turned in the end of his left. In which direction he going is now?....
QA->Transformers, Microphones, Induction coil, Generators, Motors, Induction coil work on the principle of?....
QA->A charge of current in neighbouring coil will induce (contribute) a voltage (emf) in a coil is termed as?....
QA->At the time of short-circuit; what will be the current in the circuit?....
QA->At the time of short-circuit, what will be the current in the circuit?....
MCQ->In the circuit below, if diodes and the moving coil millimeter are assumed to be ideal if mA reading is , find Vm. ....
MCQ->The diode and the moving coil milliammeter of figure are assumed to be ideal. The meter reading is ....
MCQ->Consider the following statements regarding sources or error in a Q-meter: If a coil with resistance R is connected in direct measurement mode and if the residual resistance of Q-meter is 0.1 R, then the measure Q of the coil would be 1.1 times the actual Q.If the inductance to be measured is less than 0.1 mH, the error due to presence of residual inductance cannot be neglected.The presence of distributed capacitance in a coil modifies the effective Q of the coil. Which of the above statements are correct?....
MCQ->The current capability of power diodes can be increased by placing two or more of the diodes in ________, and the PIV rating can be increased by stacking the diodes in ________.....
MCQ->Match the following: List I (Instrument) List II (Parameters) A.Moving coil galvanometer1.High inertia, soft spring controlB.Ballistic galvanometer2.No control, high dampingC.Vibration galvanometer3.Soft spring control, critical dampingD.Moving coil flux meter4.Low inertia, tuned spring control

....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution