Question Set

1. In a circular waveguide TE21 mode has lowest cutoff frequency



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 01.05 am
    Some applications require dual polarization capability. Circular waveguide has this capability. These analysis uses cylindrical coordinates. In circular waveguide TE11 mode has the lowest cut off frequency and is the dominant mode. If D is diameter of waveguide λc = 1.706 D for TE11 mode λc = 1.029 D for TE21 mode λc = 0.82 D for TE01 mode λc = 1.306 D for TM01 mode.
Show Similar Question And Answers
QA->A circular disc of copper has a symmetrical hole at its center. The disc is uniformly heated. The diameter of the hole will?....
QA->Which element has the lowest electron affinity?....
QA->Which contenent has the lowest growth rate of population?....
QA->Which petroleum refinery product has the lowest boiling point?....
QA->Which continent has the lowest birth and death rates?....
MCQ->In a circular waveguide TE21 mode has lowest cutoff frequency....
MCQ->Match the following: List I List II A.Ratio of maximum energy stored to energy dissipated per cycle1.Propagation constantB.TEM mode is loss less medium2.Cutoff frequency is zeroC.Ratio of frequency in radian to phase velocity of EM wave3.Quality factor of cavityD.TEM is the mode of lowest cutoff frequency4.Cylindrical waveguide

....
MCQ->Consider the following statements Usable bandwidth of ridge wave guide is more than that of rectangular waveguide.For a given value of TM10 cutoff frequency the cross section of ridge wave guide is lesser that that of rect angular waveguide.Ridge wave guide has higher conductor losser than a rectangular waveguide.Ridge guide has higher conductor losser than a rectangular waveguide. Which of the above statements are correct?....
MCQ->Assertion (A): In TE10 mode the cutoff frequency of rectangular waveguide is where a is the broad dimension and c is velocity of light.Reason (R): TE10 mode is the dominant mode in rectangular waveguide.

....
MCQ->Assertion (A): In circular waveguide the attenuation of TE01 mode decreases as the operating frequency increases.Reason (R): The wall currents in a circular waveguide in TEQ1 mode are completely circumferential.

....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution