Question Set

1. A coil has resistance R and inductance L. At ω = ∞ the phase angle between voltage and current is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 01.06 am
    When ω = ∞, XL = ωL = ∞.
Show Similar Question And Answers
QA->A charge of current in neighbouring coil will induce (contribute) a voltage (emf) in a coil is termed as?....
QA->The device used for converting current from a lower voltage to a higher voltage is known as?....
QA->A man who can swim 48 m/minute in still water. He swims 200 m against the current and 200 m with the current. If the difference between those two times is 10 minutes, what is the speed of the current?....
QA->A man who can swim 48 m/minute in still water. He swims 200 m against the current and 200 m with the current. If the difference between those two times is 10 minutes, what is the speed of the current?....
QA->Transformers, Microphones, Induction coil, Generators, Motors, Induction coil work on the principle of?....
MCQ->Consider the following statements for a driving point function F(jω): Re F(jω) is an even function of ω and is 0 or positive for all values of ω.Im F(jω) is an even function of ω and is 0 or positive for all values of ω.Re F(jω) is an odd function of ω and is 0 or negative for all values of ω.Re F(s) = 0 for Re s = 0. Which one of the statements given above is/are correct?....
MCQ->A coil has resistance R and inductance L. At ω = ∞ the phase angle between voltage and current is....
MCQ->Consider the following statements regarding sources or error in a Q-meter: If a coil with resistance R is connected in direct measurement mode and if the residual resistance of Q-meter is 0.1 R, then the measure Q of the coil would be 1.1 times the actual Q.If the inductance to be measured is less than 0.1 mH, the error due to presence of residual inductance cannot be neglected.The presence of distributed capacitance in a coil modifies the effective Q of the coil. Which of the above statements are correct?....
MCQ->Consider the common emitter amplifier shown below with the following circuit parameters: β = 100, gm = 0.3861 A/V, r0 = ∞ rp = 259 Ω, Rs = 1 kΩ, RB = 93 kΩ, RC = 250 Ω, RL = 1 kW, C1 = ∞ and C2 = 4.7mF. The resistance seen by the source Vs is....
MCQ->Consider the common emitter amplifier shown below with the following circuit parameters: β = 100, gm = 0.3861 A/V, r0 = ∞ rp = 259 Ω, Rs = 1 kΩ, RB = 93 kΩ, RC = 250 Ω, RL = 1 kW, C1 = ∞ and C2 = 4.7mF. The lower cut-off frequency due to C2 is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution