Question Set

1. As temperature increases, the temperature coefficient of a metal





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 01.06 am
    It a t is temperature coefficient at t°C and a 0 is temperature coefficient at 0°C. .
Show Similar Question And Answers
QA->If temperature rises; what will be the coefficient of viscosity of liquid?....
QA->If temperature rises, what will be the coefficient of viscosity of liquid?....
QA->Coefficient of linear expansion always …….. with the increase in temperature?....
QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....
QA->When the temperature increases; what does the angle of contact of a liquid?....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->Consider the following statements: The conductivity of a metal has negative temperature coefficient since: The electron concentration increases with temperature.The electron mobility decreases with temperature.The electron-lattice scattering rate increases with temperature. Which of the above statements is/are correct?....
MCQ->Coefficient of discharge Cd is equal to (where Cc = Coefficient of contraction, Cv = Coefficient of velocity, and Cr = Coefficient of resistance)....
MCQ->Consider the following statements regarding tensile test diagrams for carbon steel with varying carbon contents : As the carbon content increases 1. the ultimate strength of steel decreases 2. the elongation before fracture increases 3. the ductility of the metal decreases 4. the ultimate strength increases. Of these statements :....
MCQ->As temperature increases, the temperature coefficient of metals increases.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution