1. A practical Parallel resonant circuit has a coil in Parallel with a 0.14 μf capacitor. The coil has an inductance of 1 mH and a resistance of 10 ohms. The Q of the circuit is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 01.08 am
    .
Show Similar Question And Answers
QA->Transformers, Microphones, Induction coil, Generators, Motors, Induction coil work on the principle of?....
QA->A charge of current in neighbouring coil will induce (contribute) a voltage (emf) in a coil is termed as?....
QA->.If three resistances 6 ohm,4 ohm and 3 ohm are connected in parallel,what will be the total resistance?....
QA->Which instrument regulates the resistance or current in a circuit?....
QA->The unit of Inductance?....
MCQ->A practical Parallel resonant circuit has a coil in Parallel with a 0.14 μf capacitor. The coil has an inductance of 1 mH and a resistance of 10 ohms. The Q of the circuit is....
MCQ->A parallel resonant band-pass filter consists of a 90 resistor in series with a parallel network made up of a 60 mH coil and a 0.02 F capacitor. The output is taken across the capacitor/coil. The coil winding has a resistance of 20 . What is the center frequency of the filter?....
MCQ->A coil of resistance R and inductance L has a capacitor C in parallel with it. The source frequency is adjusted to a value equal to resonant frequency. Another capacitor C is added in parallel with the above circuit, the source current will....
MCQ->A coil of resistance R and inductance L is connected in series with 10 mF capacitor. The resonant frequency is 1000 Hz. Another 10 F capacitor is connected in parallel with the above capacitor. The new resonance frequency will be....
MCQ->Consider the following statements regarding sources or error in a Q-meter: If a coil with resistance R is connected in direct measurement mode and if the residual resistance of Q-meter is 0.1 R, then the measure Q of the coil would be 1.1 times the actual Q.If the inductance to be measured is less than 0.1 mH, the error due to presence of residual inductance cannot be neglected.The presence of distributed capacitance in a coil modifies the effective Q of the coil. Which of the above statements are correct?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution