Question Set

1. Which of the following devices has metal-silicon junction?





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....
QA->Which of the following groups consists of only input devices?....
QA->The unidirectional property of a pn-junction is useful for its use as which thing?....
QA->The famous statue in front of the Govt. Secretariat, Thiruvananthapuram from which the name ‘Statue Junction’ is evolved, is that of?....
QA->Junction (n)....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->Which of the following conditions must be satisfied for a transistor to remain under saturation? Its collector to base junction should be under forward bias.Its collector to base junction should be under reverse bias.Its emitter to base junction should be under reverse bias.Its emitter to base junction should be under forward bias. Select the correct answer from the codes given below:....
MCQ->Which of the following devices has metal-silicon junction?....
MCQ->Silicon is doped with boron to a concentration of 4 x 1017 atoms/cm3. Assuming the intrinsic carrier concentration of silicon to be 1.5 x 1010/cm3 and the value of to be 25mV at 300K. Compared to undoped silicon, the Fermi level of doped silicon....
MCQ->Which of the following characteristics of a silicon p-n junction diode make it suitable for use as ideal diode? It has low saturation current.It has high value of cut in voltage.It can withstand large reverse voltage.When compared with germanium diode, silicon diode shows a lower degree of temperature dependence under reverse conditions. Select the answer using the given below....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution