Question Set

1. The signal m(t) = 10 cos 100 p t is sampled at the rate of Fs = 75 Hz, then determine signal after sampling.





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->If sin x = cos x then x = …………......
QA->The piece of hardware that converts your computer’s digital signal to an analog signal that can travel over telephone lines is called a–....
QA->At his usual rowing rate, Rahul can travel 12 miles downstream in a certain river in 6 hrs less than it takes him to travel the same distance upstream. But if he could double his usual rowing rate for this 24 mile round trip, the downstream 12 miles would then take only one hour less than the upstream 12 miles. What is the speed of the current in miles per hour?....
QA->At his usual rowing rate, Ram can travel 12 miles downstream in a certain river in 6 hrs less than it takes him to travel the same distance upstream. But if he could double his usual rowing rate for this 24 mile round trip, the downstream 12 miles would then take only one hour less than the upstream 12 miles. What is the speed of the current in miles per hour?....
QA->A man is facing East, then the turns left and goes 10 m, then turns right and goes 5 m, then goes 5 m to the South and from there 5 m to West. In which direction is he, from his original place ?....
MCQ->The signal m(t) = 10 cos 100 p t is sampled at the rate of Fs = 75 Hz, then determine signal after sampling.....
MCQ->An audio signal of FM radio station is sampled at a rate of 15% above the Nyquist rate. Signal is sampled in 512 levels and bandwidth of the signal is 4 KHz. The minimum bandwidth required to transmit this signal will be....
MCQ->A signal f(t) = cos 10p t + 3 cos 4p t is instantaneously sampled. The maximum allowable value of sampling interval Ts in sec is....
MCQ->A signal x(t) = 100 cos (24p x 103t) is ideally sampled with a sampling period of 50 μ sec and then passed through an ideal low pass filter with cut off frequency of 15 kHz Which of the following frequencies are present at the filter output?....
MCQ->The analog signal m(t) is given below m(t) = 4 cos 100 p t + 8 sin 200 p t + cos 300 p t, the Nyquist sampling rate will be....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution