Question Set

1. The ball joints are used on the tie-rod ends, because they





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Tie rod ends have the following threads:....
QA->A main in a train moving at a constant velocity drops a ball on the platform. The path of the ball as seen by an observer standing on the platform is?....
QA->Tough tissues in joints....
QA->What is the fluid that lubricates and cushions the movable joints between the bones?....
QA->Study of joints?....
MCQ->The ball joints are used on the tie-rod ends, because they....
MCQ->A 600 mm long and 50 mm diameter rod of steel (E = 200 GPa, α = 12 x 10-6/°C) is attached at the ends to unyielding supports. When the temperature is 30°C there is no stress in the rod. After the temperature of the rod drops to - 20°C, the axial stress in the rod will be....
MCQ->A rod shown in the given figure is such that the lower part is made of steel and the upper part is made of copper. Both the ends of the rod are rigidly clamped. If an axial force P is applied at the junction of the two metals, given that the ratio Esteel/ECopper is equal to 2, then the force in the copper rod would be ....
MCQ->Lap joints are preferred over butt joints in soldering/brazing, because these joints are....
MCQ->A ball of mass 1 kg moving with a velocity 2 m/s collides directly with a m2 stationary ball of mass 2 kg. If the first ball comes to rest after the impact, what is the velocity of the second ball after impact ?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution