Question Set

1. A worm gear is used as the pinion for the rack and pinion type of steering gearbox, because it





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->In an automobile gear transmission the counter shaft drive gear is meshed with the gear on the:....
QA->Which one is the steering gear:....
QA->Go to rack and ruin....
QA->Which type of gear permits lower position of propeller shaft?....
QA->Who is the Chairman of the Mission Steering Group of NRHM?....
MCQ->A worm gear is used as the pinion for the rack and pinion type of steering gearbox, because it....
MCQ->Gear A has a weight of 1.5 lb, a radius of 0.2 ft, and a radius of gyration of ko = 0.13ft. The coefficient of friction between the gear rack B and the horizontal surface is = 0.3. If the rack has a weight of 0.8 lb and is initially sliding to the left with a velocity of (vB)2 = 8 ft/s to the left. Neglect friction between the rack and the gear and assume that the gear exerts only a horizontal force on the rack.....
MCQ->In rack and pinion gear box the rack is attached to....
MCQ->The Ackerman steering gear mechanism is preferred to the Davis steering gear mechanism, because....
MCQ->In a single threaded worm and worm wheel, the number of teeth on the worm is 50. The diameter of the effort wheel is 100 mm and that of load drum is 50 mm. The velocity ratio is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution