Question Set

1. Which of the following when used in ordinary low carbon steels, makes the metal ductile and of good bending qualities?





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Which material is very hard and very ductile?....
QA->An electronic device makes a beep after 60 sec.Another device makes a beep after ever 62sec.They beeped together at 10am.The time when they will next make a beep together at the earliest,is....
QA->Which was the great Hindu king who combined in himself the qualities of Samudragupta and Ashoka?....
QA->.....is used for comparing the e.m.f.s, of cells, measurements of the thermal e.m.f.s, large potential differences and currents. It is also used for measuring low resistances.?....
QA->In a certain code 743 means Mangoes are good; 657 means Eat good food; and 934 means Mangoes are ripe. Which digit means ripe in that language?....
MCQ->Which of the following when used in ordinary low carbon steels, makes the metal ductile and of good bending qualities?....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->Low carbon steels are those in which carbon percentage is around....
MCQ->Which of the following is universally employed as the low expansion metal in the bimetallic thermometer, which is an iron-nickel alloy containing 36% nickel and has very low co-efficient of expansion (l/20th of ordinary metals) ?....
MCQ->Steels with high carbon equivalent have poor weldability, because in these steels during welding....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution