Question Set

1. Which of the following impurity in cast iron promotes graphite nodule formation and increases the fluidity of the molten metal?





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The oldest rocks in the earth's crust were once molten; and came from deep inside the earth. The molten rock; called magma; spewed out in volcanic eruptions during the earth;s early life and solidified into hard rock's called?....
QA->The only gaseous plant hormone which promotes fruit growth and ripening is?....
QA->Name the type that are cast blocks of metal that are kept in the top shelf of the wooden case is called....
QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....
QA->What is the Molten rock below the surface of the earth?....
MCQ->Which of the following impurity in cast iron promotes graphite nodule formation and increases the fluidity of the molten metal?....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->When carbon in the cast iron is principally in the form of graphite, the cast iron will be of....
MCQ->Nodular cast iron is produced by adding __________ to the molten cast iron.....
MCQ->Nodular cast iron is produced by adding -------to the molten cast iron....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution