The process used for relieving the internal stresses previously set up in the Metal and for increasing the machinability of steel, is ?->(Show Answer!)

Question Set

1. The process used for relieving the internal stresses previously set up in the Metal and for increasing the machinability of steel, is

Show Similar Question And Answers

QA->Stainless Steel ഉണ്ടാക്കാൻ Steel ൻ്റെകുടെ ചേർക്കുന്ന ലോഹം....

QA->Which steel firm has won the Prime Minister’s trophy for ‘Best Performing Integrated Steel Plant’ in 2015-16?....

QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....

QA->The Hindustan steel Ltd. Durgapur has been set up with the help of which country?....

QA->In which process the internal energy of a system remains constant?....

MCQ->The process used for relieving the internal stresses previously set up in the Metal and for increasing the machinability of steel, is....

MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....

MCQ->Pick out the wrong statement about the machinability of metals. Machinability of a metal....

MCQ->The bending moment at a section tends to bend or deflect the beam and the internal stresses resist its bending. The resistance offered by the internal stresses, to the bending, is called....

MCQ->Match the following: List I (Set operation) List II (Set operator)A.Set equality1.-B.Set inclusion2.=C.Set intersection3.< =D.Set difference4.∗

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution