Question Set

1. Which of the following gives the correct order of increasing hot hardness of cutting tool materials?





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The order of appearance of the following with increasing temperature during the refining of crude oil is?....
QA->A pendulum clock is set to give correct time at the sea level. This clock is moved to a hill station at an altitude of 2500m above the sea level. In order to keep correct time on the hill station, the length of the pendulum?....
QA->Correct sentences among the following are: ) The tea is too hot that I cannot drink (2) Work hard, lest you should miss the chance (3) Unless you study well, you will fail (4) Unless you study well, you will pass....
QA->Which elements are arranged in increasing order of atomic weight, every eighth element has properties similar to the first this law had been given by?....
QA->A​ ​white​ ​solid’A’on​ ​heating​ ​gives​ ​off​ ​a​ ​gas​ ​which​ ​turns​ ​lime​ ​water milky.The​ residue​ ​is​ ​yellow​ ​when​ ​hot​ ​but​ ​turns​ ​white​ ​on​ ​cooling​ ​.The solid​ ​A​ ​is:....
MCQ->Which of the following gives the correct order of increasing hot hardness of cutting tool materials?....
MCQ->The correct sequence of tool materials in increasing order of their ability to retain their hot hardness is....
MCQ->Read the following statements as regards register pairs in microprocessor 8085B represents B, C pair with B as high order register and C as low order register.D represents D, E pair with D as high order register and E as low order register.H represents H, L pair with H as high order register and L as low order register. Which of the above statements are correct?....
MCQ->When power shovels are operated under different site conditions (in terms of material handled), what is the correct sequence in the increasing order of the ouput for the following materials ? 1. Well - blasted rock 2. Hard and tough clay 3. Poorly blasted rock 4. Moist loam or sand Select the correct answer using the code given below :....
MCQ->Carbon percentage in high speed steel tool material is 0.6 to 1.0. The hardness of carbon tool steels is increased, when it is alloyed with....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution