Question Set

1. A hemispherical tank of radius (R) containing liquid upto height (H1) has an orifice of cross-sectional area (a) at its bottom. The time required to lower the level of liquid from (H1) to (H2) will be


Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The velocity of flow of a liquid through an orifice at the bottom of a tank depends on the?....
QA->Average height of 10 students in a class is 150 cm. A boy of height 160 cm left the class and a boy of height 148 cm is admitted. Then what is the average height of the students in the class now?....
QA->The pressure at the bottom of a liquid tank does not depend on which area?....
QA->The ratio between the radius and height of a circular one of volume 314 cm (cube) is 5:Its height is....
QA->A large tank having a small hole at the bottom is filled with water to a height h. if the stream of water coming out of the hole is directed vertically upwards it will?....
MCQ->A hemispherical tank of radius (R) containing liquid upto height (H1) has an orifice of cross-sectional area (a) at its bottom. The time required to lower the level of liquid from (H1) to (H2) will be....
MCQ->The discharge through a small rectangular orifice is given by (where Cd = Coefficient of discharge for the orifice, a = Cross-sectional area of the orifice, h = Height of the liquid above the centre of the orifice)....
MCQ->The discharge through a large rectangular orifice is given by (where H1 = Height of the liquid above the top of the orifice, H2 = Height of the liquid above the bottom of the orifice, b = Breadth of the orifice, and Cd = Coefficient of discharge)....
MCQ->The discharge through a wholly drowned orifice is given by (where H1 = Height of water (on the upstream side) above the top of the orifice, H2 = Height of water (on the downstream side) above the bottom of the orifice, and H = Difference between two water levels on either side of the orifice)....
MCQ->Height of liquid in agitation tank is normally maintained equal to the tank diameter. However, if the tank is too tall and a large liquid hold up is desired, then two or more impellers mounted on the same shaft may be used. The clearance between the tank bottom and the bottom most impeller should be about (where, D = impeller diameter)....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution