Question Set

1. The dedendum circle diameter is equal to (where φ = Pressure angle)





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->If the diameter of a circle is increased by 100%, its area is increased by :....
QA->If the diameter of a circle is doubled.Its area is increased by _______times....
QA->Post and Telegraph circle got bifuricated and Kerala Postal Circle came into existence in?....
QA->A steel wire when bent in the form of a square encloses an area of 121 sq. cm. If the same wire is bent into the form of a circle, the area of the circle is—....
QA->A liquid will not wet the surface of solid if the angle of contact is which angle?....
MCQ->Consider the following statements about conditions that make a metal semiconductor contact rectifying N type semiconductor with work function φs more than work function φM of metalN type semiconductor with work function φs less than work function φM of metalP type semiconductor with work function φs more than work function φM of metalP type semiconductor with work function φs less than work function φM of metal. Of these statements....
MCQ->The dedendum circle diameter is equal to (where φ = Pressure angle)....
MCQ->Consider the following statements : If two planes at right angles carry only shear stress of magnitude 'q', then the 1. diameter of Mohr's circle would equal 2q 2. centre of the Mohr's circle would lie at the origin 3. principal stresses are unlike and have magnitude 'q' 4. angle between the principal plane and the plane of maximum shear would be equal to 45° Of these statements :....
MCQ->If φsh is flux of shunt magnet, φse is flux of series magnet, ish is eddy current due to φse, the torque in an induction wattmeter is proportional to....
MCQ->A 40° slope is excavated to a depth of 10 m in a deep layer of saturated clay of unit weight 20 kN.m3; the relevant shear strength parameters are cu = 70 kN/m2 and φu = 0. The rock ledge is at a great depth. The Taylor's stability coefficient for φu = 0 and 40° slope angle is 0.18. The factor of safety of the slope is :....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution