Toggle navigation
Home
KPSC Previous Question Papers
Article Category
kerala psc
upsc
General
Popular Pages
Multiple Choice Question in aptitude-area
Multiple Choice Question in non-verbal-reasoning-grouping-of-images
Multiple Choice Question in aptitude-compound-interest
Multiple Choice Question in engineering-mechanics-kinetics-of-a-particle-impulse-and-momentum
Multiple Choice Question in electronic-devices-bipolar-junction-transistors
Multiple Choice Question in 035/2016
Multiple Choice Question in database-database-redesign
Question Answer in malayalam-kerala-psc-questions
Multiple Choice Question in malayalam-kerala-psc-questions
Multiple Choice Question in current-affairs-2017-03-05
Question Answer in KERALA PSC
Multiple Choice Question in KERALA PSC
Question Answer Bank
Multiple Choice Question Bank
Question Answer Category
Multiple Choice Question Category
Home
->
Multiple Choice Questions
Question Set
mechanical engineering machine design
1. The initial tension (in newtons) in a bolt used for making a fluid tight joint like steam engine cover joints, is calculated by the relation (where d = Nominal diameter of bolt in mm)
(A): 1420 d
(B): 1680 d
(C): 2080 d
(D): 2840 d
Previous Question
Show Answer
Next Question
Add Tags
Report Error
Show Marks
Ask Your Doubts Here
Type in
(Press Ctrl+g to toggle between English and the chosen language)
Post reply
Comments
Show Similar Question And Answers
QA->The process of transfer of heat from one point of a fluid to another part of a fluid by the movement of fluid itself is called?....
QA->What is the fluid that lubricates and cushions the movable joints between the bones?....
QA->The power of the Engine is calculated by?....
QA->The Steam Engine invented by James Watt was called?....
QA->Who invented Steam Engine in 1769 ?....
MCQ->The initial tension (in newtons) in a bolt used for making a fluid tight joint like steam engine cover joints, is calculated by the relation (where d = Nominal diameter of bolt in mm)....
MCQ->If P1 is the initial tension due to tightening up the bolt and P2 is the external load on the bolt, then the resultant load (P) on a bolt may be obtained by using the relation (where a = Ratio of elasticity of connected parts to the elasticity of bolt)....
MCQ->Fact 1: All dogs like to run. Fact 2: Some dogs like to swim. Fact 3: Some dogs look like their masters. If the first three statements are facts, which of the following statements must also be a fact? I: All dogs who like to swim look like their masters. II: Dogs who like to swim also like to run. III: Dogs who like to run do not look like their masters.....
MCQ->The brake power (B.P.) of the engine is given by (where W = Brake load or dead load in newtons, l = Length of arm in metres, N = Speed of engine in r.p.m., S - Spring balance reading in newtons, D = Dia. of brake drum in metres, and d = Dia. of rope in metres)....
MCQ->The bolts of smaller diameter than M16 are not permitted in making fluid tight joints.....
×
×
Type The Issue
×
Your Marks
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...
Privacy
|
Terms And Conditions
Question ANSWER With Solution