Question Set

1. In a belt drive, if the pulley diameter is doubled keeping the tension and belt width constant, then it will be necessary to





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Assume that 20 cows and 40 goats can be kept for 10 days for Rs. If the cost of keeping 5 goats is the same as the cost of keeping 1 cow, what will be the cost for keeping 50 cows and 30 goats for 12 days?....
QA->A major belt of asteroids is located between Mars and Jupiter. What is the approximate average distance between the Sun and this major asteroid belt?....
QA->A man is facing East, then the turns left and goes 10 m, then turns right and goes 5 m, then goes 5 m to the South and from there 5 m to West. In which direction is he, from his original place ?....
QA->John started from his home and walked 12 km.Then he took a right turn and walked 4 km.Then again,he took a right turn and walked 8 km and finally took another right turn and walked 1 km.How far is he from his home now?....
QA->The length of a rectangular floor is 2 meters more than its width and its perimeter is 20 meters, then its area is....
MCQ->In a belt drive, if the pulley diameter is doubled keeping the tension and belt width constant, then it will be necessary to....
MCQ->In a flat belt drive, if the slip between the driver and belt is 1 %, between the belt and follower is 3% and driver and follower pulley diameters are equal, then velocity ratio of the drive will be....
MCQ->The following steps are necessary to obtain sufficient accuracy with the tape : 1. Keeping uniform tension on tape for each measurement: 2. "Breaking" tape on slopes are necessary to keep the tape level. 3. Keeping accurate count of the stations. 4. Keeping the tape on the line being measured. The correct sequence of these steps is....
MCQ->If diameter of driver and driven pulley are 10 cm and 20 cm respectively and if,the driver pulley rotates at a speed of 200 rpm,find the speed of driven pulley:....
MCQ->The diameters of driver and driven pulleys of a simple belt drive are 100 mm and 50 mm respectively.If the speed of driver pulley 1000 rpm,the speed of driven pulley is:....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution