Question Set

1. In designing a flange coupling, the pitch circle diameter of bolts is taken as (where d = Diameter of the shaft)





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Post and Telegraph circle got bifuricated and Kerala Postal Circle came into existence in?....
QA->A steel wire when bent in the form of a square encloses an area of 121 sq. cm. If the same wire is bent into the form of a circle, the area of the circle is—....
QA->If the diameter of a circle is increased by 100%, its area is increased by :....
QA->If the diameter of a circle is doubled.Its area is increased by _______times....
QA->Which type of gear permits lower position of propeller shaft?....
MCQ->In designing a flange coupling, the pitch circle diameter of bolts is taken as (where d = Diameter of the shaft)....
MCQ->In a marine flange coupling, the pitch circle diameter of bolts is taken as....
MCQ->For a shaft diameter of 200 mm, the number of bolts in a marine flange coupling should be....
MCQ->For a shaft diameter of 100 mm, the number of bolts in a flange coupling should be....
MCQ->Consider the following statements in respect of plate girders : 1. A large number of cover plates are provided over flange angles so that curtailed flanges match the bending moment diagram exactly. 2. At least one cover plate should extend over the entire span so that rain water may not enter and corrode the connections. 3. A minimum of one-third of flange area should be provided in flange angles and balance in flange cover plates for stability. Which of the statements given above are correct ?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution