A key is normally made from a cold rolled mild steel bars. ?->(Show Answer!)

Question Set

1. A key is normally made from a cold rolled mild steel bars.

Show Similar Question And Answers

QA->Stainless Steel ഉണ്ടാക്കാൻ Steel ൻ്റെകുടെ ചേർക്കുന്ന ലോഹം....

QA->Which steel firm has won the Prime Minister’s trophy for ‘Best Performing Integrated Steel Plant’ in 2015-16?....

QA->കീബോർഡിലെ Escape Key (Esc Key) എവിടെയാണ് കാണാൻ സാധിക്കുക? ....

QA->Which is the Master Key of the Key Board?....

QA->All type bars rest in the....

MCQ->A key is normally made from a cold rolled mild steel bars.....

MCQ->Square steel key is normally strong in failure by shear & crushing. Keys are normally made of __________ steel bars.....

MCQ->Match List-I with List-II and select the correct answer using the codes below A)Mediterranean 1.Temperate cycle is moderated by marine influence B)Marine west coast 2.Warm summers and cold winters with three months below freezing.Very large annual temperature range C)Dry mid latitude 3.Strong temperature cycle with large annual range.Warm summers to hot and cold winters to very cold D)Moist continental 4.Temperature range is moderate with warm to hot summers with cold winters A B C D....

MCQ->A mild steel specimen is under uni-axial tensile stress. Young's modulus and yield stress for mild steel are 2 x 105 MPa and 250 MPa respectively. The maximum amount of strain energy per unit volume that can be stored in this speciment without permanent set, is....

MCQ->Four reinforcing bars of 30 mm diameter each, are bundled in contact. The lower two bars extend up to end supports. The distance between the points of termination of the upper bars, is kept....

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution