Question Set

1. An operation of enlarging the end of a hole cylindrically is known as grooving.



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A metal plate with a circular hole at the centre is heated. What will happen to the area of the hole?....
QA->A metal sheet with circular hole is heated. what change will be in the hole?....
QA->A large tank having a small hole at the bottom is filled with water to a height h. if the stream of water coming out of the hole is directed vertically upwards it will?....
QA->A metal sheet with a circular hole is heated. The hole will?....
QA->A circular disc of copper has a symmetrical hole at its center. The disc is uniformly heated. The diameter of the hole will?....
MCQ->An operation of enlarging the end of a hole cylindrically is known as grooving.....
MCQ->The grooving is an operation of....
MCQ->The enlarging of an existing circular hole with a rotating single point tool is called....
MCQ->In seive plate column, holes are drilled or punched in sizes ranging from 2.5 to 12 mm (5 mm being widely used). The hole pitch is normally __________ times the hole diameter to give the required hole area.....
MCQ->In a P-type semiconductor, the conductivity due to holes (= σP) is equal to e = charge of hole, μP = hole mobility, P = hole concentration,....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution