Question Set

1. In metal cutting operations, the shear angle is the angle made by the shear plane with the





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->If the angle between two plane mirrors is 60°; then how many number of image will be formed?....
QA->How many image can a man see if he stands between two plane mirrors inclined at an angle of 60°?....
QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....
QA->Mercury is transported in metal containers made of which metal?....
QA->A liquid will not wet the surface of solid if the angle of contact is which angle?....
MCQ->In metal cutting operations, the shear angle is the angle made by the shear plane with the....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->In this type of view, the cutting plane line indicates both the location of the cutting plane and the direction of sight:....
MCQ->When a cutting plane coincides with a centerline, the cutting plane line takes precedence.....
MCQ->The normal stress and shear stress on a failure plane in a drained test on a cohesion less soil are 0kg/cm2 each,the angle that the failure plane makes with the major prinicipal plane will be:....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution