Question Set

1. The parameter which completely defines the chip formation in a metal cutting process is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....
QA->In electric supply lines in India; which parameter is kept constant?....
QA->In electric supply lines in India, which parameter is kept constant?....
QA->Which Constitutional Article defines the `Provision in case of failure of Constitutional Authority in the state?....
QA->On the basis of the process of their formation; which soil is formed differently from the other three?....
MCQ->The parameter which completely defines the chip formation in a metal cutting process is....
MCQ->If RT, Rh represent condition for reciprocity in case of transmission parameter and hybrid parameter respectively and similarly ST, Sh represent condition for symmetry in case of transmission parameter and hybrid parameter respectively then match the following : (1) RT (a) A = D (2) Rh (b) h12 = h21 (3) ST (c) AD - BC = 1 (4) Sh (d) h12 = - h21 (e) B = c (f) Δh = 1....
MCQ->The various stages of formation of snow are listed below : 1. Formation of ice crystals 2. Formation of snow pallets 3. Formation of snow flakes 4. Formationof snow crystals 5. Formation of rimed crystals Which one of the following sequences is correct ?....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->In an orthogonal cutting, the depth of cut is halved and the feed rate is double. If the chip thickness ratio is unaffected with the changed cutting conditions, the actual chip thickness will be....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution