Question Set

1. A lathe with four steps on the cone pulley and with backgears will have





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The ratio of bases of a cylinder and a cone are in the ratio 3: Volume of cylinder and cone are in the ratio 9: then their heights are in the ratio?....
QA->‘I have been touring different parts of the world. During these travels, I have had the good fortune to come into contact with several saints and maharshis. But I have frankly to admit that I have never come across one who is spiritually greater than Swami Sree Narayana Guru of Kerala” Whose words are these?....
QA->“During my travels throughout the world, I have had the good fortune to come in contact with several saints and maharishis... But I have frankly to admit that I have never come across one who is spiritually greater than Swami Narayana Guru or a person who is at par with him in spiritual attainment.” Who paid tribute in the above words after visiting Sree Narayana Guru?....
QA->Sankaracharya founded four mutts in four comers of India;They are?....
QA->Who founded four mathas in the four comers of India?....
MCQ->A lathe with four steps on the cone pulley and with backgears will have....
MCQ->If diameter of driver and driven pulley are 10 cm and 20 cm respectively and if,the driver pulley rotates at a speed of 200 rpm,find the speed of driven pulley:....
MCQ->What is the height of a circular cone? I.  The area of that cone is equal to the area of a rectangle whose length is 33 cm.  II.  The area of the base of that cone is 154 sq. cm.....
MCQ->The following steps are involved in laying a sewer in a trench : 1. Transferring the center line of the sewer to the bottom trench. 2. Setting sight rails over the trench. 3. Driving pegs to the level of the invert line of the sewer. 4. Placing the sewer of these steps is The correct sequence of these steps is....
MCQ->In order to have a good grip on the pulley, the V-belt should touch the bottom of the groove in the pulley.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution