Question Set

1. The sliding pairs, turning pairs and screw pairs form lower pairs.



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A cyclist goes 40 km towards East and then turning to right he goes 40 km. Again he turn to his left and goes 20 kn. After this he turns to his left and goes 40 km, then again turns right and goes 10 km. I-low far is he from his starting point ?....
QA->‘His marriage was the turning point in his life' - ശരിയായ തർജമ ഏത്? ....
QA->A turning point....
QA->Which of the following is one (single) handed soil turning plough ?....
QA->“Forget not that the lower classes, the ignorant, the poor, the illiterate, the cobbler, the sweeper are thy flesh and blood, thy brothers” – These words are related to?....
MCQ->The sliding pairs, turning pairs and screw pairs form lower pairs.....
MCQ->The mechanism in which two are turning pairs and two are sliding pairs, is called a....
MCQ->A double-slider four-bar mechanism consisting of two turning pairs and two sliding pairs,will have a degree of freedom equal to:....
MCQ->In a simple screw jack, the pitch of the screw is 9 mm and length of the handle operating the screw is 45 cm. The velocity ratio of the system is....
MCQ->While designing a screw in a screw jack against buckling failure, the end conditions for the screw are taken as....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution