Question Set

1. The radial distance from the top of a tooth to the bottom of a tooth in a meshing gear, is called





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->In an automobile gear transmission the counter shaft drive gear is meshed with the gear on the:....
QA->Who said ‘Climbing to the top demands strength; whether it is to the top of Mount Everest or to the top of your career’?....
QA->The angle of elevation of the top of a hill at the foot of a tower is 60° and the angle of elevation of the top of the tower from the foot of the hill is 30°. If the tower is 50 m high, the height of the hill is—....
QA->The spatial frequency of a wave, either in cycles per unit distance or radians per unit distance is called?....
QA->A man started to walk East. After moving a distance he turned to his right. After moving a distance he turned to his right again. After moving a little he turned in the end of his left. In which direction he going is now?....
MCQ->The radial distance from the top of a tooth to the bottom of a tooth in a meshing gear, is called....
MCQ->The radial distance from the top of a tooth to the bottom of a tooth is called clearance....
MCQ->The radial distance of a tooth from the pitch circle to the bottom of the tooth is called....
MCQ->The radial distance of a tooth from the pitch circle to the top of the tooth is called....
MCQ->Twenty degree full depth involute profited 21 tooth pinion and 39 tooth gear are in mesh.If the modue is 5 mm,the centre distance between the gear pair will be:....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution