Question Set

1. A pouring basin acts as a reservoir for the molten metal.



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The oldest rocks in the earth's crust were once molten; and came from deep inside the earth. The molten rock; called magma; spewed out in volcanic eruptions during the earth;s early life and solidified into hard rock's called?....
QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....
QA->Name the irrigation project which has entered into the Guiness Book of World Records for pouring 32,100 cubic meters of concrete in 24 hours?....
QA->What is the Molten rock below the surface of the earth?....
QA->Mercury is transported in metal containers made of which metal?....
MCQ->A pouring basin acts as a reservoir for the molten metal.....
MCQ->In order to deliver molten metal from pouring basin to gate, a __________ is used.....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->A pattern is used to make the mould cavity for pouring the molten metal for casting.....
MCQ->Consider the cascade structure of two filters. Consider the following statements. If f1 < f2 then it acts like band-pass filterIf f1 < f2 then it acts like band-pass only if HPF follows LPF in other case it acts like a band stop filterIf f1 > f2 then it acts all stop filter The correct statements are:....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution