Question Set

1. The operation of giving impressions of figures, letters or designs on sheet metal parts, is known as embossing.



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A word is given in capital letters. It is followed by four words. Out of these four words, three cannot be formed from the letters of the word in capital letters. Point out the word which can be formed from the letters of the given word in capital letters— ARCHITECTURE....
QA->A metal sheet with circular hole is heated. what change will be in the hole?....
QA->A metal sheet with a circular hole is heated. The hole will?....
QA->A word given in Capital Letters is followed by four answer words. Out of these only one can be formed by using the letters of the given words. Find out that word— ENVIRONMENT....
QA->A word given in capital letters is followed by four words. Out of these only one cannot be formed by using the letters of the given word. Find out that word— REVOLUTIONARY....
MCQ->The operation of giving impressions of figures, letters or designs on sheet metal parts, is known as embossing.....
MCQ->Metal embossing is –process for producing raised or sunken designs or relief in sheet metal....
MCQ->Select a figure from amongst the Answer Figures which will continue the same series as established by the five Problem Figures.Problem Figures:                          Answer Figures:  (A)     (B)     (C)     (D)     (E)       (1)     (2)     (3)     (4)     (5)

....
MCQ->The second figure in the first unit of the problem figures bears a certain relationship to the first figure. Similarly, one of the figures in the answer figures bears the same relationship to either the first or the second figure in the second unit of the problem figures. You are therefore to locate the figure which would fit in the place of the question mark(?).....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution