1. Which of the following types of connections can use full duplex? Hub to hub Switch to switch Host to host Switch to hub Switch to host





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 01.56 am
    Hubs cannot run full-duplex Ethernet. Full duplex must be used on a point-to-point connection between two devices capable of running full duplex. Switches and hosts can run full duplex between each other, but a hub can never run full duplex.
Show Similar Question And Answers
QA->Which is the following types of materials act as effective catalysts?....
QA->During which period of evolution man discovered the use of jute and began to use cloth made of jute?....
QA->The south Indian city which is the hub of automobile industry?....
QA->A semiconductor device used to amplify or switch electronic signals and electrical . power?....
QA->To visit which countries, Indians over 65 and under 15 years can now use Aadhaar Card as a valid travel document?....
MCQ->Which three statements are true about the operation of a full-duplex Ethernet network? There are no collisions in full-duplex mode. A dedicated switch port is required for each full-duplex node. Ethernet hub ports are preconfigured for full-duplex mode. In a full-duplex environment, the host network card must check for the availability of the network media before transmitting. The host network card and the switch port must be capable of operating in full-duplex mode.....
MCQ->Which of the following types of connections can use full duplex? Hub to hub Switch to switch Host to host Switch to hub Switch to host....
MCQ->Which of the following are unique characteristics of half-duplex Ethernet when compared to full-duplex Ethernet? Half-duplex Ethernet operates in a shared collision domain. Half-duplex Ethernet operates in a private collision domain. Half-duplex Ethernet has higher effective throughput. Half-duplex Ethernet has lower effective throughput.....
MCQ->You have 10 users plugged into a hub running 10Mbps half-duplex. There is a server connected to the switch running 10Mbps half-duplex as well. How much bandwidth does each host have to the server?....
MCQ->You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy? Switch(config-if)# ip access-group 10 Switch(config-if)# switchport port-security maximum 1 Switch(config)# access-list 10 permit ip host 1 Switch(config-if)# switchport port-security violation shutdown Switch(config)# mac-address-table secure....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions