Question Set

1. You telnet into a remote device and type debug ip rip, but no output from the debug command is seen. What could the problem be?





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 01.56 am
    To see console messages through your Telnet session, you must enter the terminal monitor command.
Show Similar Question And Answers
QA->Correct sentences among the following are: ) The tea is too hot that I cannot drink (2) Work hard, lest you should miss the chance (3) Unless you study well, you will fail (4) Unless you study well, you will pass....
QA->Which one of the following is an output device?....
QA->Who said ‘Happiness is when what you think; what you say; and what you do are in harmony’?....
QA->If you have a Power point show you created and want to send using E-mail to another teacher you can add the show to your E-mail message as an______....
QA->Which Indian political leader will be seen in a never-seen-before avatar on August 12, 2019 when he ventures into the wilderness of Uttarakhand along with Bear Grylls, the host of the popular television show 'Man vs Wild' on Discovery Channel?....
MCQ->You telnet into a remote device and type debug ip rip, but no output from the debug command is seen. What could the problem be?....
MCQ->You install the Routing and Remote Access service on a Windows 2000 Server computer in your network. Your network is not directly connected to the Internet and uses the private IP address range 192.168.0.0. When you use Routing and Remote Access to dial in to the server, your computer connects successfully, but you are unable to access any resources. When you try to piiig servers by using their IP addresses, you receive the following message: "Request timed out." When you run the ipconfig command, it shows that your dial-up connection has been given the IP address 169.254.75.182. What should you do to resolve the problem?....
MCQ->You want to provide Internet access for the clients on your network. You decide to use Network Address Translation (NAT). You have a Windows 2000 computer you try to establish a secure Virtual Private Networking session with. You try connecting to the Remote Windows 2000 computer using L2TP. You are unable to establish a connection with the remote node using L2TP. You are able to make a connection with another computer in your same office. Why are you unable to make a connection.to the remote location?....
MCQ->You are unsuccessful in telnetting into a remote device. What could the problem be? IP addresses are incorrect. Access control list is filtering Telnet. There is a defective serial cable. The VTY password is missing.....
MCQ->You telnet to a router and make your necessary changes; now you want to end the Telnet session. What command do you type in?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution