Question Set

1. Which command would you use to apply an access list to a router interface?





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 01.57 am
    To apply an access list, the proper command is ip access-group 101 in.
Show Similar Question And Answers
QA->Correct sentences among the following are: ) The tea is too hot that I cannot drink (2) Work hard, lest you should miss the chance (3) Unless you study well, you will fail (4) Unless you study well, you will pass....
QA->State list, Union list, Concurrent list are included in which of the following schedule....
QA->State list, Union list, Concurrent list are included in which of the following schedule....
QA->.What is the maximum font size you can apply for any character?....
QA->If you scored cannon; which game would you be playing?....
MCQ->Network 206.143.5.0 was assigned to the Acme Company to connect to its ISP. The administrator of Acme would like to configure one router with the commands to access the Internet. Which commands could be configured on the Gateway router to allow Internet access to the entire network? Gateway(config)# ip route 0.0.0.0 0.0.0.0 206.143.5.2 Gateway(config)# router rip Gateway(config-router)# network 206.143.5.0 Gateway(config-router)# network 206.143.5.0 default....
MCQ->You have your laptop directly connected into a router's Ethernet port. Which of the following are among the requirements for the copy flash tftp command to be successful? TFTP server software must be running on the router. TFTP server software must be running on your laptop. The Ethernet cable connecting the laptop directly into the router's Ethernet port must be a straight-through cable. The laptop must be on the same subnet as the router's Ethernet interface. The copy flash tftp command must be supplied the IP address of the laptop.....
MCQ->You are working on a router that has established privilege levels that restrict access to certain functions. You discover that you are not able to execute the command show running-configuration. How can you view and confirm the access lists that have been applied to the Ethernet 0 interface on your router?....
MCQ->You get a call from a network administrator who tells you that he typed the following into his router: Router(config)#router ospf 1 Router(config-router)#network 10.0.0.0 255.0.0.0 area 0 He tells you he still can't see any routes in the routing table. What configuration error did the administrator make?....
MCQ->Which command would you use to apply an access list to a router interface?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution