Question Set

1. You want to run the new 802.1w on your switches. Which of the following would enable this protocol?





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 01.57 am
    802.1w is the also called Rapid Spanning Tree Protocol. It is not enabled by default on Cisco switches, but it is a better STP to run since it has all the fixes that the Cisco extensions provide with 802.1d.
Show Similar Question And Answers
QA->If you have a Power point show you created and want to send using E-mail to another teacher you can add the show to your E-mail message as an______....
QA->Correct sentences among the following are: ) The tea is too hot that I cannot drink (2) Work hard, lest you should miss the chance (3) Unless you study well, you will fail (4) Unless you study well, you will pass....
QA->If you want to visit sambhar lake; to which state you will go?....
QA->If you want to visit sambhar lake, to which state you will go?....
QA->Which of these will help you to minimize blurriness that can occur when your camera moves while you take a shot ?....
MCQ->To configure the VLAN trunking protocol to communicate VLAN information between two switches, what two requirements must be met? Each end of the trunk link must be set to the IEEE 802.1e encapsulation. The VTP management domain name of both switches must be set the same. All ports on both the switches must be set as access ports. One of the two switches must be configured as a VTP server. A rollover cable is required to connect the two switches together. A router must be used to forward VTP traffic between VLANs.....
MCQ->You want to run the new 802.1w on your switches. Which of the following would enable this protocol?....
MCQ->You install the Routing and Remote Access service on a Windows 2000 Server computer in your network. Your network is not directly connected to the Internet and uses the private IP address range 192.168.0.0. When you use Routing and Remote Access to dial in to the server, your computer connects successfully, but you are unable to access any resources. When you try to piiig servers by using their IP addresses, you receive the following message: "Request timed out." When you run the ipconfig command, it shows that your dial-up connection has been given the IP address 169.254.75.182. What should you do to resolve the problem?....
MCQ->Consider the following statements A 4 : 16 decoder can be constructed (with enable i/p) by Using four 2 : 4 decoders (each with an enable i/p) onlyUsing five 2 : 4 decoders (each with an enable i/p) onlyUsing two 3 : 8 decoders (each with an enable i/p) onlyUsing two 3 : 8 decoders (each with an enable i/p) only Which of the statements given above is/are correct?....
MCQ->Which of the following would be good reasons to run NAT? You need to connect to the Internet and your hosts don't have globally unique IP addresses. You change to a new ISP that requires you to renumber your network. You don't want any hosts connecting to the Internet. You require two intranets with duplicate addresses to merge.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution