Question Set

1. When a router is connected to a Frame Relay WAN link using a serial DTE interface, how is the clock rate determined?





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 01.57 am
    Clocking on a serial interface is always provided by the CSU/DSU (DCE device). However, if you do not have a CSU/DSU in your nonproduction test environment, then you need to supply clocking with the clock rate command on the serial interface of the router with the DCE cable attached.
Show Similar Question And Answers
QA->Which public sector bank has become the first in the country to link savings bank interest rate to RBI repo rate?....
QA->A mouse connected to parallel interface is called....
QA->A pendulum clock is set to give correct time at the sea level. This clock is moved to a hill station at an altitude of 2500m above the sea level. In order to keep correct time on the hill station, the length of the pendulum?....
QA->To make a notebook act as a desktop model, the notebook can be connected to a ………………….. which is connected to a monitor-and other devices.....
QA->The clock rate of a processor is measured in?....
MCQ->When a router is connected to a Frame Relay WAN link using a serial DTE interface, how is the clock rate determined?....
MCQ->You need to configure a router for a Frame Relay connection to a non-Cisco router. Which of the following commands will prepare the WAN interface of the router for this connection?....
MCQ->You have an interface on a router with the IP address of 192.168.192.10/29. Including the router interface, how many hosts can have IP addresses on the LAN attached to the router interface?....
MCQ->You have your laptop directly connected into a router's Ethernet port. Which of the following are among the requirements for the copy flash tftp command to be successful? TFTP server software must be running on the router. TFTP server software must be running on your laptop. The Ethernet cable connecting the laptop directly into the router's Ethernet port must be a straight-through cable. The laptop must be on the same subnet as the router's Ethernet interface. The copy flash tftp command must be supplied the IP address of the laptop.....
MCQ->A group of 2m - 1 routers are interconnected in a centralized binary tree, with router at each tree node. Router I communicate with router J by sending a message to the root of the tree. The root then sends the message back down to J. Then find the mean router-router path length.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution