Toggle navigation
Home
KPSC Previous Question Papers
Article Category
kerala psc
upsc
General
Popular Pages
Multiple Choice Question in engineering-mechanics-kinetics-of-a-particle-impulse-and-momentum
Multiple Choice Question in database-database-redesign
Question Answer in malayalam-kerala-psc-questions
Multiple Choice Question in malayalam-kerala-psc-questions
Multiple Choice Question in current-affairs-2017-03-05
Question Answer in kerala-psc-questions-in-malayalam
Multiple Choice Question in kerala-psc-questions-in-malayalam
Multiple Choice Question in electronics-and-communication-engineering-electronic-devices-and-circuits
Multiple Choice Question in database-sql-for-database-construction-and-application-processing
Multiple Choice Question in 035/2016
Question Answer in Antonyms
Question Answer in KERALA PSC
Multiple Choice Question in KERALA PSC
Question Answer Bank
Multiple Choice Question Bank
Question Answer Category
Multiple Choice Question Category
Home
->
Multiple Choice Questions
Question Set
technical drawing isometric drawings
1. The Offset tool should only be used for placing ________ in an isometric drawing.
(A): circles
(B): horizontal lines
(C): none of the above
(D): vertical lines
Previous Question
Show Answer
Next Question
Add Tags
Report Error
Show Marks
Ask Your Doubts Here
Type in
(Press Ctrl+g to toggle between English and the chosen language)
Post reply
Comments
Show Similar Question And Answers
QA->The process where the inner pages of a section is deliberately printed offset slightly towards spine fold ?....
QA->Dr Ambedkar had said that Article ___ should normally remain a 'dead letter' and would be used only in the 'last resort'.?....
QA->Dr. Ambedkar had said the "Article ___ should normally remain a 'dead letter' and would be used only in the 'last resort'.?....
QA->The museum? You should ________ at the third stop.....
QA->Placing a thing beside another....
MCQ->The Offset tool should only be used for placing ________ in an isometric drawing.....
MCQ->The primary difference between isometric drawings and perspective drawings is that in an isometric drawing both vertical and horizontal lines remain parallel while in a perspective drawing both horizontal and vertical lines are in line with an apparent vanishing point.....
MCQ->The AutoCAD Center Mark tool can be used in an isometric drawing as you would use it in any conventional orthographic drawing.....
MCQ->Isometric drawings, unlike isometric projections, are drawn using the full length measurements of the actual drawing and lack foreshortening.....
MCQ->An isometric drawing is about 50% smaller than the isometric projection.....
×
×
Type The Issue
×
Your Marks
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...
Privacy
|
Terms And Conditions
Question ANSWER With Solution