1. In this type of concrete, the steel is pretensioned before the superimposed load is applied:





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Stainless Steel ഉണ്ടാക്കാൻ Steel ൻ്റെകുടെ ചേർക്കുന്ന ലോഹം....
QA->Which steel firm has won the Prime Minister’s trophy for ‘Best Performing Integrated Steel Plant’ in 2015-16?....
QA->Who were the inventors of concrete and the technique of binding stone and bricks?....
QA->Name the irrigation project which has entered into the Guiness Book of World Records for pouring 32,100 cubic meters of concrete in 24 hours?....
QA->A concrete outcome of the Wavell Plan was the?....
MCQ->In this type of concrete, the steel is pretensioned before the superimposed load is applied:....
MCQ->Which of the following statements are correct about datatypes in C#.NET? Every datatype is either a value type or a reference type. Value types are always created on the heap. Reference types are always created on the stack. Mapping of every value type to a type in Common Type System facilitates Interoperability in C#.NET. Every reference type gets mapped to a type in Common Type System.....
MCQ->Consider the following statements pertaining to a pile group and a single pile at failure : 1. In loose and medium dense sands, the failure load per pile in a group will generally be greater than the failure load for a single pile. 2. In cohesive soils, the failure load per pile in a group will be greater than failure load for a single pile. 3. For piles driven in dense sands, the failure load per pile in a group is greater than the failure load for a single pile. 4. When the pile spacing is greater than 10 times the pile diameter, the failure loads per pile in a group and forly same in both sands and clays. Of these statements :....
MCQ->A voltage regulator with a no-load output dc voltage of 12 V is connected to a load with a resistance of 10 . If the load resistance decreases to 7.5 , the load voltage will decrease to 10.9 V. The load current will be ________, and the percent load regulation is ________.....
MCQ->As per IS : 800-1984 the maximum allowable slenderness ratio of compression members carrying forces resulting from dead load and superimposed load is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution