Question Set

1. As per IS : 800-1984 the maximum allowable slenderness ratio of compression members carrying forces resulting from dead load and superimposed load is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The ratio of bases of a cylinder and a cone are in the ratio 3: Volume of cylinder and cone are in the ratio 9: then their heights are in the ratio?....
QA->As per the revised Goods and Services Tax (GST) norms, the GST on Haj and Kailash Mansarovar Yatra has been reduced from 18 per cent to how much per cent?....
QA->Five equal forces of 10 N each are applied at one point and all are lying in one plane. If angles between them are equal, the resultant of these forces wil be?....
QA->In a mixture of 35 litres, the ratio of milk and water is 5 : Another 5 litres of milk is added to the mixture. The ratio of milk and water in the new mixture is—....
QA->കൃഷ്ണൻ അവന്റെ വീട്ടിൽനിന്നും ആദ്യം 500 മീറ്റർ വടക്കോട്ട് നടന്നു. പിന്നീട് വലത്തോട്ട് തിരിഞ്ഞ് 800 മീറ്ററും ഇടത്തോട്ട് തിരിഞ്ഞ് 800 മീറ്ററും നടന്നു. എ ങ്കിൽ പുറപ്പെട്ട സ്ഥലത്തുനിന്നും നേരെ അയാളി ലേക്കുള്ള ദൂരം എത്ര? ....
MCQ->As per IS : 800-1984 the maximum allowable slenderness ratio of compression members carrying forces resulting from dead load and superimposed load is....
MCQ->The maximum permissible slenderness ratio of compression member carrying dead and superimposed load, is....
MCQ->Maximum permissible slenderness ratio of compression members which carry dead and superimposed load, is....
MCQ->Consider the following statements pertaining to a pile group and a single pile at failure : 1. In loose and medium dense sands, the failure load per pile in a group will generally be greater than the failure load for a single pile. 2. In cohesive soils, the failure load per pile in a group will be greater than failure load for a single pile. 3. For piles driven in dense sands, the failure load per pile in a group is greater than the failure load for a single pile. 4. When the pile spacing is greater than 10 times the pile diameter, the failure loads per pile in a group and forly same in both sands and clays. Of these statements :....
MCQ->If the area of cross-section of a single angle discontinuous strut is 30 cm2 and allowable working stress corresponding to its slenderness ratio is 625 kg/cm2, the safe load carrying capacity of the member, is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution