Question Set

1. Welding drawings are a special type of this kind of drawing:





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->THE NATIONAL SPECIAL OLYMPIC FOR SPECIAL CHILDREN WAS ORGANIZED IN WHICH CITY?....
QA->.....is a special type of binocular, through which a double photograph snapped from two different angles by a two-lensed camera is viewed in solid relief.?....
QA->Canola refers to special type of oil seed mustard varieties bred for human consumption. The main characteristics of these varieties is that the?....
QA->Which type of memory is not directly addressable by the CPU and requires special software called EMS?....
QA->‘Vitruvian Man’ also called the Canon of Proportions is the world famous drawing by?....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->Welding drawings are a special type of this kind of drawing:....
MCQ->The primary difference between isometric drawings and perspective drawings is that in an isometric drawing both vertical and horizontal lines remain parallel while in a perspective drawing both horizontal and vertical lines are in line with an apparent vanishing point.....
MCQ->Which of the following statements are correct about datatypes in C#.NET? Every datatype is either a value type or a reference type. Value types are always created on the heap. Reference types are always created on the stack. Mapping of every value type to a type in Common Type System facilitates Interoperability in C#.NET. Every reference type gets mapped to a type in Common Type System.....
MCQ->In the questions below are given three statements followed by two conclusions numbered I and II. You have to take the given statements to be true even if they seem to be at variance from commonlyknown facts and then decidewhich of the given conclusions logicallyfollows from the statements disregardingcommonly known facts. Statements :Some drawings are paintings.All drawings are sketches.Some sketches are interesting. Conclusions :I. All paintings are sketches.II. Some interesting are drawings....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution