Question Set

1. I opened the bottle ......... a screw driver.?





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A Closed bottle containing water at room temperature is taken to the moon and then the lid is opened. The water will?....
QA->A cold bottle is taken from a refrigerator and weighed. As time progresses we will find?....
QA->തമിഴ്‌നാട്ടിലെ ആദ്യ വനിതാ Ambulance Driver?....
QA->Jamie Chadwick, who became the first female driver to win MRF Challenge title, is from which country?....
QA->Where was the first Post-Office in Travancore (also of Kerala) was opened in 1857 ?....
MCQ->In this section,each passage consists of 6 sentences.The first and sixth sentences are given in the beginning as S1 and S6.The middle four sentences in each are removed and jumbled up.These are labelled P,Q,R,S.You are required to find out the proper order of the sentences and mark accordingly on the answer sheet S1:At the roadside a driver will be asked to blow through a small glass tube into a plastic bag S6:The driver will be asked to go to the police station P:And if the color change did not reach the line the driver cannot be punished under the new law. Q:Inside the tube are chemically treated crystals which change color if the driver has alcohol on his brreath R:But if the color change did reach the line,then the test has proved positive S:If the color change goes beyond a certainline marked on the tube then this indicates the driver is probably over the specified limit The proper sequence should be....
MCQ->I opened the bottle ......... a screw driver.?....
MCQ->In a simple screw jack, the pitch of the screw is 9 mm and length of the handle operating the screw is 45 cm. The velocity ratio of the system is....
MCQ->While designing a screw in a screw jack against buckling failure, the end conditions for the screw are taken as....
MCQ->It is required to cut screw threads of 2 mm pitch on a lathe. The lead screw has a pitch of 6 mm. If the spindle speed is 60 r.p.m., then the speed of lead screw will be....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution