Question Set

1. The temperature of furnace used for heat-treating steel is measured and controlled by an instrument called:





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Dwarfness can be controlled by treating the plant with which acid?....
QA->The inventor of the Steel Furnace is?....
QA->The iron obtained direct from the blast furnace is called?....
QA->Stainless Steel ഉണ്ടാക്കാൻ Steel ൻ്റെകുടെ ചേർക്കുന്ന ലോഹം....
QA->Which steel firm has won the Prime Minister’s trophy for ‘Best Performing Integrated Steel Plant’ in 2015-16?....
MCQ->The temperature of furnace used for heat-treating steel is measured and controlled by an instrument called:....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->The radiation heat flux from a heating element at a temperature of 800°C, in a furnace maintained at 300°C is 8 kW/m2. The flux, when the element temperature is increased to 1000°C for the same furnace temperature is....
MCQ->Bleaching powder containing 25% of available chlorine is used for treating the drinking water is 2 mg/lt,the bleaching powder required for treating 1 litre of water is....
MCQ->When hardening steel by the carburising process,after the steel has been heated to the correct temperature and for the correct amount of time,furnace is shut off and the steel is:....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution