Question Set

1. Which catalyst is used in the manufacture of ethylene oxide by oxidation of ethylene ?





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The temperature for the Haber process is 500° C Catalyst used in Haber process?....
QA->The catalyst used for the production of Sulphuric acid?....
QA->The metal that is used as a catalyst in the hydrogenation of oils is?....
QA->Which is the artificial form of aluminium oxide used for making refractory crucibles?....
QA->Ethylene reacts with sulphur monochloride to form which gas?....
MCQ->Which catalyst is used in the manufacture of ethylene oxide by oxidation of ethylene ?....
MCQ->Ethylene oxide is produced by oxidation of ethylene in presence of AgO catalyst at....
MCQ->During nitric acid manufacture, catalytic oxidation of ammonia at 800°C in presence of platinum catalyst produces nitrogen oxide. Conversion of NH3 to NO is about __________ percent.....
MCQ->Use of catalyst is a must in the ammonia manufacture, because the reaction is reversible as well as the heat of dissociation of N2 & H2 is high. The presence of promoter along with the catalyst helps in __________ of the catalyst.....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution