Question Set

1. Choose the correct set of dimensions of viscosity that are equivalent (where, F, M, L, T are dimensions for force, mass, length and time respectively).





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A pendulum clock is set to give correct time at the sea level. This clock is moved to a hill station at an altitude of 2500m above the sea level. In order to keep correct time on the hill station, the length of the pendulum?....
QA->Viscosity of gas is less than viscosity of?....
QA->Present ages of Kiran and Syam are in the ratio of 5:4 respectively. Three years hence, the ratio of their ages will become 11:9 respectively. What is Syam"s present age in years?....
QA->Present ages of Kiran and Syam are in the ratio of 5 : 4 respectively. Three years hence, the ratio of their ages will become 11 : 9 respectively. What is Syam"s present age in years?....
QA->A train of length 150 meters took 8 seconds to cross a bridge of length 250 meters. Time taken by the train to cross a telephone post is....
MCQ->Choose the correct set of dimensions of viscosity that are equivalent (where, F, M, L, T are dimensions for force, mass, length and time respectively).....
MCQ->S1: A force of exists between everybody in the universe. P : Normally it is very small but when the one of the bodies is a planet, like earth, the force is considerable. Q : It has been investigated by many scientists including Galileo and Newton. R : Everything on or near the surface of the earth is attracted by the mass of earth. S : This gravitational force depends on the mass of the bodies involved. S6: The greater the mass, the greater is the earth's force of attraction on it. We can call this force of attraction gravity. The Proper sequence should be:....
MCQ->The crane provides a long-reach capacity by using the telescopic boom segment DE. The entire boom is supported by a pin at A and by the telescopic hydraulic cylinder BC, which can be considered as a two-force member. The rated load capacity of the crane is measured by a maximum force developed in the hydraulic cylinder. If this maximum force is developed when the boom supports a mass m = 6 Mg and its length is l = 40 and = 60°, determine the greatest mass that can be supported when the boom length is extended to l = 50 m and = 45°. Neglect the weight of the boom and the size of the pulley at E. Assume the crane does not overturn. Note: when = 60° BC is vertical; however, when = 45° this is not the case.....
MCQ->Correct viscosity of furnace oil at the burner tip for proper atomisation is about 25 centistokes. To reduce the viscosity of high viscosity furnace oil (250 centistokes) to the correct atomisation viscosity (i.e. 25 cst), it should be preheated to about____°C.....
MCQ->If Sample class has a Length property with get and set accessors then which of the following statements will work correctly? Sample.Length = 20; Sample m = new Sample(); m.Length = 10; Console.WriteLine(Sample.Length); Sample m = new Sample(); int len; len = m.Length; Sample m = new Sample(); m.Length = m.Length + 20;....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution