Question Set

1. A hydraulic press has a ram of 10 cms in diameter and a plunger of 1 cm in diameter. The force required on the plunger to raise a weight of 10 tons on the ram is __________ kg.





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The average weight of A, B and C is 45 kg. If the average weight of A and B be 40 kg and that of B and C be 43 kg, what is the weight of B?....
QA->The first printing press in Kerala, CMS Press was established at?....
QA->In Kiran’s opinion, his weight is greater than 65 kg but less than 72 kg. His brother does not agree with Kiran and he thinks that Kiran’s weight is greater than 60 kg but less than 70 kg. His mother’s view is that his weight cannot be greater than 68 kg. If all are them are correct in their estimation, what is the average of different probable weights of Kiran?....
QA->‘Hydraulic brakes’ and ‘Hydraulic lift’ are devices; why are fluids used in them?....
QA->‘Hydraulic brakes’ and ‘Hydraulic lift’ are devices, why are fluids used in them?....
MCQ->A hydraulic press has a ram of 10 cms in diameter and a plunger of 1 cm in diameter. The force required on the plunger to raise a weight of 10 tons on the ram is __________ kg.....
MCQ->Consider the following statements associated with the laws of weights in the theory of erros : 1. If an equation is multiplied by its own weight, then the weight of the resulting equation is equal to the reciprocal of the weight of the equation. 2. The weight of the algebraic sum of two or more quantities is equal to the reciprocal of the sum of the individual weights. 3. If the quantity of a given weight is multiplied by a factor, then the weight of the result is obtained by dividing its given weight by the square root of that factor. 4. If the quantity of a given weight is divided by a factor, then the weight of the result is obtained by multiplying its given weight by the square of that factor. Of these statements :....
MCQ->Consider the following statements about a hydraulic ram : 1. Hydraulic ram does not need external power. 2. It works on the fundamental principle of water hammer. 3. The efficiency of a hydraulic ram is only of the order of 8 to 10%. 4. It can be termed as a low, intermittent discharge low-head pumping installation. Which of these statements are correct ?....
MCQ->The crane provides a long-reach capacity by using the telescopic boom segment DE. The entire boom is supported by a pin at A and by the telescopic hydraulic cylinder BC, which can be considered as a two-force member. The rated load capacity of the crane is measured by a maximum force developed in the hydraulic cylinder. If this maximum force is developed when the boom supports a mass m = 6 Mg and its length is l = 40 and = 60°, determine the greatest mass that can be supported when the boom length is extended to l = 50 m and = 45°. Neglect the weight of the boom and the size of the pulley at E. Assume the crane does not overturn. Note: when = 60° BC is vertical; however, when = 45° this is not the case.....
MCQ->Consider the following statements relating to hydraulic gradient line and energy gradient line 1. In the case of a fluid flowing in a pipeline, hydraulic gradient line and energy gradient line may coincide. 2. The line joining the points representing piezometric heads is known as hydraulic gradient line. 3. In the case of ideal fluid, energy gradient line is always horizontal. 4. Hydraulic gradient line has a downward slope in the case of flow through pipes. Of these statements :....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution