Toggle navigation
Home
KPSC Previous Question Papers
Article Category
kerala psc
upsc
General
Popular Pages
Multiple Choice Question in aptitude-area
Multiple Choice Question in non-verbal-reasoning-grouping-of-images
Multiple Choice Question in aptitude-compound-interest
Multiple Choice Question in engineering-mechanics-kinetics-of-a-particle-impulse-and-momentum
Multiple Choice Question in database-database-redesign
Multiple Choice Question in 035/2016
Question Answer in malayalam-kerala-psc-questions
Multiple Choice Question in malayalam-kerala-psc-questions
Multiple Choice Question in current-affairs-2017-03-05
Multiple Choice Question in electronic-devices-bipolar-junction-transistors
Question Answer in Malayalam General Knowledge
Question Answer Bank
Multiple Choice Question Bank
Question Answer Category
Multiple Choice Question Category
Home
->
Multiple Choice Questions
Question Set
chemical engineering process equipment and plant design
1. Cooling water fouling factors vary in the range of 0.001 to 0.003
(A): (BTU/hr.ft2 . °F)-1
(B): (kcal/hr. m. °C)-1
(C): (kcal/hr.m2 .°C)-1
(D): (W/m2.°K)-1
Previous Question
Show Answer
Next Question
Add Tags
Report Error
Show Marks
Ask Your Doubts Here
Type in
(Press Ctrl+g to toggle between English and the chosen language)
Post reply
Comments
Show Similar Question And Answers
QA->1/01 + 01/ 001 + 001/0001 + 0001/ 00, 001= ?....
QA->The rate of cooling of hot water will be faster than the?....
QA->A white solid’A’on heating gives off a gas which turns lime water milky.The residue is yellow when hot but turns white on cooling .The solid A is:....
QA->Which indigenous missile has recently been upgraded from 290 kilometers range to 500 kilometers range?....
QA->2/1+5/01+3/.001+1 എത്ര?....
MCQ->Cooling water fouling factors vary in the range of 0.001 to 0.003....
MCQ->H2S is being absorbed in a gas absorber unit. The height of the transfer unit based on the overall mass transfer coefficient on the gas side is 0.4 m. The equilibrium data is given by, y = 1.5 x. The bulk concentration of H2S has to be reduced from 0.05 to 0.001 mole fraction in the gas side. The height of the tower (in metres) corresponding to an operating line given by, y = 5x + 0.001 is....
MCQ->Consider the following statements : I. Traits may be classified in terms of the modality through which they are expressed II. Any single trait may represent the outcome of the operation of enviornmental factors, hereditary factors or both III. Traits that result from environmental conditions are called environmental mould traits IV. Traits that reflect hereditary factors are called constitutional traits. Of the statements :....
MCQ->Demand Pull factors and Cost Push factors are factors involved in the phenomena of ______?....
MCQ->A centrifugal pump is used to pump water through a horizontal distance of 150 m, and then raised to an overhead tank 10 m above. The pipe is smooth with an I.D of 50 mm. What head (m of water) must the pump generate at its exit (E) to deliver water at a flow rate of 0.001 m3/s? The Fanning friction factor, f is 0.0062. ....
×
×
Type The Issue
×
Your Marks
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...
Privacy
|
Terms And Conditions
Question ANSWER With Solution