Question Set

1. The operation of removal of impurities or clay adhering to iron ores, is known as





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Which operation was the continuation of operation Desert storm?....
QA->The process of extraction of metals from their ores; and then refining them for use is known as?....
QA->Flux reacts with the impurities to form fusible material. which is known as which name?....
QA->Process of adding controlled impurities to a pure semiconductor is known as?....
QA->Substance added to ore to remove impurities is known as?....
MCQ->The operation of removal of impurities or clay adhering to iron ores, is known as....
MCQ->Statements:Some bricks are stones. Some stones are rocks. All rocks are clay. No clay is sand. Conclusions: I.Some stones are clay. II.Some bricks are sand. III.Some rocks are sand. IV.No brick is sand.....
MCQ->Match the following:A. Article 61 1. Removal of Deputy Chairman of Rajya Sabha B. Article 67 2. Impeachement of President C. Article 94 3. Removal of Vice President D. Article 90 4. Removal of Speaker A B C D?....
MCQ->The fuel mostly used in blast furnace for extracting pig iron from iron ores is....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution