Question Set

1. The maximum permissible deflection for a gantry girder, spanning over 6 m, on which an EOT (electric overhead travelling) crane of capacity 200 kN is operating, is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The capacity of an electric field to do work on an electric charge?....
QA->What is the maximum permissible period between two sessions of a State Legislative Assembly?....
QA->The hydro electric project which has the greatest production capacity?....
QA->ഹിമാലയൻ പുള്ളിപ്പുലിയും (Snow Leopard) കരിങ്കഴുത്തുള്ള കൊക്കിനെയും (Black-necked crane) ഔദ്യോഗിക മൃഗവും ഔദ്യോഗിക പക്ഷിയുമായി തെരഞ്ഞെടുത്ത കേന്ദ്രഭരണ പ്രദേശം ഏത്?....
QA->Rotation of the earth causes deflection of wind by which force?....
MCQ->The maximum permissible deflection for a gantry girder, spanning over 6 m, on which an EOT (electric overhead travelling) crane of capacity 200 kN is operating, is....
MCQ->The crane provides a long-reach capacity by using the telescopic boom segment DE. The entire boom is supported by a pin at A and by the telescopic hydraulic cylinder BC, which can be considered as a two-force member. The rated load capacity of the crane is measured by a maximum force developed in the hydraulic cylinder. If this maximum force is developed when the boom supports a mass m = 6 Mg and its length is l = 40 and = 60°, determine the greatest mass that can be supported when the boom length is extended to l = 50 m and = 45°. Neglect the weight of the boom and the size of the pulley at E. Assume the crane does not overturn. Note: when = 60° BC is vertical; however, when = 45° this is not the case.....
MCQ->The minimum thickness of the web plate for a crane gantry plate girder with a lifting load exceeding 15 tonnes, is....
MCQ->When the depth of a plate girder is at least n times the depth of vertical leg of the flange angles, the girder is known as deep plate girder, if n is....
MCQ->Consider the following statements regarding a beam of uniform cross-section simply supported at its ends and carrying a concentrated load at one of its third points : 1. Its deflection under the load will be maximum. 2. The bending moment under the load will be maximum. 3. The deflection at the mid-point of the span will be maximum. 4. The slope at the nearer support will be maximum. Of these statements :....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution